Kit, Stand, Horz, W/M4x15, TX0, Hex, 920334-01L

Kit, Stand, Horz, W/M4x15, TX0, Hex, 920334-01L

SKU:
920334-01 or 02Y1W8
$29.00
(No reviews yet)
Condition:
New
Current Stock:
5
Adding to cart… The item has been added
Description

Kit, Stand, Horz, W/M4x15, TX0, Hex, 920334-01L or 02Y1W8

 

NOTE:
For PxN, Tx0, and Tx0D: You need to purchase separately (or have received
with your client) the client horizontal stand/VESA bracket with the ‘hex’ holes. For Tx0,
use PN 920334-01L. For PxN and Tx0D, use PN 920334-11L.
 
Mounting N03D, PxN, Tx0, and Tx0D Clients:
Use the following instructions to mount the N03D, PxN, Tx0, and Tx0D client to the E bracket.
1. Preparing the Client and VESA Bracket - Remove the client from its horizontal stand/VESA bracket. On the inside ’ of the stand/bracket, slip one of the four (4) provided hex nuts into a screw hole.
 
NOTE: Use your finger to slide the hex nut across the stand/VESA bracket surface so that it easily slips into the recessed cutout.  
 
Important: You need to have the plastic bracket with the hex holes.
For Tx0, use PN 920334-01L. For PxN and Tx0D, use PN 920334-11L. (No hex holes? Contact a Dell sales representative to purchase the correct bracket for installation.) Using a Phillips-head screwdriver, attach one of the four (4) shoulder screws through the ‘outside’ bracket screw hole and into the nut (do not over-tighten).
 
Repeat for remaining three hex nuts and shoulder screws. Finally, insert the client into the stand/VESA bracket as shown, with the power button at the top, and the extended plastic ledge on the opposite side.